:	Oct 18, 2007

: Observe due care when working near a hot exhaust system.

:

Pre-catalytic converter exhaust gas temperature sensor shown, post catalytic converter and post diesel particulate filter (DPF) sensors similar.

.

: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands. Raise and support the vehicle.

.

Remove the transmission undershield.   Remove the 6 bolts.

.

:   Discard the gasket. Release the catalytic converter.   Remove and discard the 3 nuts.

.

Loosen the catalytic converter to diesel particulate filter (DPF) clamp.

.

Remove the exhaust gas temperature sensor electrical connector heat shield.   Remove the bolt.

.

Disconnect the exhaust gas temperature sensor electrical connector.

.

Remove the exhaust gas temperature sensor.   Reposition the catalytic converter.

.

Install the exhaust gas temperature sensor.   Tighten to 35 Nm (26 lb.ft).

.

Connect the exhaust gas temperature sensor electrical connector.

.

Install the exhaust gas temperature sensor connector heat shield.   Tighten the bolt to 10 Nm (7 lb.ft).

.

:   Install a new gasket. Secure the LH catalytic converter.   Tighten the nuts to 48 Nm (35 lb.ft).

.

Tighten the catalytic converter to DPF retaining clamp.   Tighten the nut to 48 Nm (35 lb.ft).

.

Install the transmission undershield.   Tighten the bolts to 10 Nm (7 lb.ft).